Sleepnet Aura Nasal CPAP Mask without Headgear

Remove the mask and the headgear from the package.

1. Place the headgear on a table, label side down with the narrowest part close to you.
2. Set the mask with the gel side down onto the center of the headgear.
3. Take each headgear strap and connect it to its respective location on the mask by  looping the Velcro® strap through the headgear slots and attaching it back to itself.
4. Once the headgear has been properly attached to the mask, follow the fitting tips below to fit the mask:
5. Detach one Velcro® strap by sliding the Velcro® loop off the quick release hook, slip the headgear over the head and center the mask on the face (Figure 1).
6. Find the detached Velcro® strap and slide the Velcro loop back on the quick release hook.
7. Be sure the headgear straps are parallel and the headgear is fully extended and flat across the back of the head.
8. Adjust the bottom headgear straps by using the tabs. After tightening, make sure the Active Headgear Connector can move freely.
   NOTE: Do NOT overtighten the headgear.
9. Adjust the upper headgear straps by using the tabs.
10. Adjust the bottom headgear straps to make sure the bottom of the mask is sealed  comfortably between the bridge of the nose and just above the upper lip.
    Note: For optimal seal and comfort, the mask should be snug, but not tight. Adjust the tension by detaching the Velcro straps, tightening or loosening the straps, and  reattaching the Velcro.
11. Connect the mask to the positive airway pressure device tubing and turn the device on to the prescribed pressure.
12. Turn head from side to side while lying on the bed and identify areas of leak that may prevent sleep.
13. If there are leaks, gently press along the Memory Wire™ to seal the leaks.
14. Adjust the headgear straps as needed. 
15. If leaks persist despite customization of Memory WireTM and adjustment of headgear straps, try moving the mask higher or lower around the nose to find the best fit.